News

4 sets 100RV-SP Vertical Slurry Pump are ready to Peru

100RV-MSP Vertical Slurry Pump is designed for handling abrasive and corrosive liquids and slurries, while submerged in sumps or pits. Suited for applications requiring greater reliability and durability than conventional vertical process pumps can offer. It is mainly used for pumping the slurries with high abrasive, strong corrosion and high concentration liquids contain suspended solid particles.

Design Features:

• Bearing Assembly – The bearings, shaft and housing are generously proportioned to avoid problems associated with the operation of cantilevered shafts in the first critical speed zones.
The assembly is grease lubricated and sealed by labyrinths; the upper is grease purged and the lower protected by a special flinger. The upper or drive end bearing is a parallel roller type whilst the lower bearing is a double taper roller with preset end float. This high performance bearing arrangement and robust shaft eliminates the need for a lower submerged bearing.
• Column Assembly – Completely fabricated from mild steel. The SPR model is elastomer covered.
• Casing – Has a simple bolt-on attachment to the base of the column. It is manufactured from a wear resistant alloy for the SP and from moulded elastomer for the SPR.
• Impeller – Double suction impellers (top and bottom entry) induce low axial bearing loads and have heavy deep vanes for maximum wear resistance and for handling large solids. Wear resistant alloys, polyurethane and moulded elastomer impellers are interchangeable. The impeller is adjusted axially within the casting during assembly by external shims under the bearing housing feet. No further adjustment is necessary.
• Upper Strainer – Drop-in metal mesh, snap-on elastomer or polyurethane for SP and SPR pumps. Strainers fit in column openings.
• Lower Strainer – Bolted metal or polyurethane for SP, moulded snap-on elastomer for SPR.
• Discharge Pipe – Metal for SP, elastomer covered for SPR. All wetted metal parts are completely rust protected.
• Submerged Bearings – None
• Agitation – An external agitator spray connection arrangement can be fitted to the pump as an option. Alternatively, a mechanical agitator is fitted to an extended shaft protruding from the impeller eye.
• Materials – Pumps can be manufactured in abrasive and corrosive resistant materials.

Installation:

Mounting the vertical pumps as simple as four through-bolts on the pump mounting plate. The motor is fully supported on the pump base itself, and can be oriented in either a shaft-up or shaft-down position depending on customer preference and space availability.

Applications:

Amostech vertical spindle pumps can be used for gravel and sand, mineral processing, chemical processing, coal preparation, effluent handling, floor sump pumping, mill scale pumping, pumping of machine tool cuttings and almost every other tank, floating dewatering or other floating pump platforms.