News

I bought a slurry pump. How to maintain it during use to extend its placement? Then Amostech has the following methods:

1) The water pressure and volume of the bearing should meet the specifications. Adjust the packing tension or replace the packing at any time to avoid leakage of the seal. Replace the shaft sleeve in time.

2) When replacing the bearing, please make sure that there is no dust in the bearing assembly and the lubricating oil is clean. When the pump is running, the bearing temperature should preferably not exceed 60-65°C, and the highest should not exceed 75°C.

3) Ensure that the motor and pump are aligned correctly, and the elastic pad in the coupling is fully functioning correctly. If it is damaged, please replace it immediately.

4) Ensure that the pump components and piping system are installed correctly and reliably.

5) Some parts of the slurry pump are easily damaged, so special attention should be paid to the wear condition of the vulnerable parts, and timely repair or replacement should be carried out when necessary. When repairing or replacing the vulnerable parts of the slurry pump, please make sure that they are properly matched and the gap is adjusted properly to prevent it from becoming uneven and worn.

6) The suction piping system of the slurry pump should not leak air. During operation, check whether the inlet is blocked. In most cases, the medium that needs to be treated by the mud pump contains solid particles, so the barrier placed in the pump pool should meet the requirements for particles to pass through the mud pump, thereby reducing the blockage of the pump due to large particles or particles. risk. The long fiber material enters the pump.

To operate the slurry pump, it should be placed on the ground, the suction pipe should be immersed in the water, and the pump should be started for filling. To operate slurry pumps and submersible slurry pumps restricted by the structure, the motor should be placed on the surface of the water, and the pump should be immersed in the water and fixed, otherwise the motor may fall into the water and be scrapped. Since the long shaft has a fixed length, the installation and operation of the pump are complicated, and the application is limited.